Makita DFJ207 Instruction Manual page 7

Installing or removing the fan unit
1. Turn the ring counterclockwise while lifting the
hook on it. Remove the ring when the mark on the ring
aligns with the slot on the fan unit.
3
► 1 . Fan unit 2. Ring 3. Hook 4. Slot 5. Mark
2. Pass the head of the fan unit into the hole on the
jacket. Set the ring onto the fan unit and turn it clock-
wise until the mark on the ring aligns with the mark
further from the slot.
2
► 1 . Mark 2. Ring 3. Fan unit
4
5
1
2
1
3
3. Pass the strip through the loop on the fan unit and
fasten the snap button.
1
► 1 . Strip
4. Attach the other fan unit to the jacket in the same
way.
5.
Connect the cable to the fan units. Support the
cable using the cable holder.
1
► 1 . Cable 2. Cable holder
6. Connect the other end of the cable to the battery
holder.
1
► 1 . Battery holder
CAUTION:
Always use the strip and snap
button to secure the fan unit to the jacket. If the
fan unit falls, it may cause an injury, or damage to the
fan unit.
Follow the installation procedure in reverse when
removing it.
7 ENGLISH
2