RIDGID R10201 Operator's Manual page 12

OPERATION
ADjUSTING THE ROTATING HANDLE
See Figure 8, page 14.
The handle can be rotated 90˚ to the left and right.
 Unplug the angle grinder.
 Depress the handle lock button and rotate the handle to
the desired position.
 Release handle lock button and make sure handle is
locked into position.
WARNING:
To prevent loss of control and possible serious
injury, always operate the grinder with the handle
locked into position.
OPERATING THE GRINDER
See Figure 9, page 14.
Always carefully select and use grinding wheels that are
recommended for the material to be ground. Make sure
that the minimum operating speed of any accessory wheel
selected is 8,000 r/min. or more. The grinding wheel provided
with the grinder is suitable for grinding welds, preparing
surfaces to be welded, grinding structural steel, and grind-
ing stainless steel.
To operate the grinder:
 Secure all work in a vise or clamp to a workbench.
DANGER:
Never use the grinder with the guard removed.
It has been designed for use only with the guard
installed. Attempting to use grinder with guard
removed will result in loose particles being thrown
against the operator resulting in serious personal
injury.
Find Quality Products Online at:
 Hold the grinder in front and away from you with
 Turn on the grinder and let the motor and grinding wheel
 Lower the grinder gradually until the grinding wheel con-
 Keep the grinder tilted at an angle from 5 to 15 de-
 Move the grinder continuously at a steady, consistent
 Use just enough pressure to keep the grinder from chat-
NOTE: Heavy pressure will decrease the grinder's speed and
put a strain on the motor. Normally the weight of the tool
alone is adequate for most grinding jobs. Use light pressure
when grinding jagged edges or loose bolts where there is the
potential for the grinder to snag on the metal edge.
 Lift the grinder away from the workpiece before turning
12 - English
GlobalTestSupply
www.
both hands, keeping the grinding wheel clear of the
workpiece.
build up to full speed.
tacts the workpiece.
grees.
WARNING:
To prevent loss of control and possible serious
personal injury, always operate the grinder
with both hands, keeping one hand on the side
handle.
pace.
NOTICE:
If the grinder is held in one spot too long, it will
gouge and cut grooves in the workpiece. If the
grinder is held at too sharp an angle, it will also
gouge the workpiece because of concentration of
pressure on a small area.
tering or bouncing.
off the grinder.
.com
sales@GlobalTestSupply.com