Table of Contents
Advertisement
G
A. ROP NO. column [ROP NO.]
B. IP address column [IP ADDRESS] [SUBNET MASK] [GATEWAY]
C. SWAP ROP No. column [SWAP ROP No]
D. CONNECTION CHECK button [CONNECTION CHECK]
E. NETWORK SEARCH button [NETWORK SEARCH]
F. REGISTER button [REGISTER]
G. Setting target selection list box [Master ROP Number]
Setting Procedure
1. Set IP addresses in [HRP1].
1.
On the [HRP1] line under [ROP NO.] (A), enter the IP address of the unit to be registered
2.
Click the [REGISTER] button (F) to confirm the [HRP1] setting.
2. Set the connections for multiple units.
Settings can be configured in the following two ways.
Register IP addresses assigned to devices in the IP address column [IP ADDRESS] [SUBNET MASK] [GATEWAY] (B) in
the same manner as with [HRP1].
Click the [NETWORK SEARCH] button (E) to retrieve the information for the ROPs in the same segment.
A list is displayed in [HRP2] to [HRP25].
Click the [REGISTER] button (F) to confirm the [HRP1] setting. Registered ROPs are displayed in the [Master ROP Number] (G) list
box.
If you want to change the ROP numbers in the list, see the following page.
"Changing the ROP numbers in the list" (see page 125)
3. Check the ROP connection on the network.
Click the [CONNECTION CHECK] button (D) in the row of the ROP NO. you need to check.
If communication is performed correctly, the red tally of the tally display of the corresponding ROP flashes for approx-
imately 3 seconds. If it does not flash, check the settings and connection.
Changing the ROP numbers in the list
If you want to change the list's ROP numbers in the step 2 above, swap the connect destination ROPs between the two ROP numbers.
1. Click ▼ in the [SWAP ROP No] column (C).
A list of ROP numbers [HRP2] to [HRP25] is displayed.
2. Select the ROP number with which you want to make the swap.
3. Click the [REGISTER] button (F) to confirm the change.
The length of time required for setting after you click the [REGISTER] button (F) is proportional to the number of ROPs
connected. When there are 25 ROPs connected, it takes up to about 10 minutes.
A
E
F
B
C
- 125 -
Software
D
Advertisement
Table of Contents
