Assembly - RIDGID HD1600M0 Owner's Manual

ASSEMBLY

Caster/Caster Foot Assembly
NOTE: Remove Powerhead Assembly
from Dust Drum prior to assembly of
Casters and Caster Feet.
1. Turn Dust Drum upside down on floor.
2. Place Caster Foot on floor. Insert the
stem of a Caster into socket of Caster
Foot.
3. Push on the Caster until the Caster ball
end snaps fully into the Socket and the
Caster swivel freely. Repeat for other
three Casters and Caster Feet.
4. Place Caster Foot with Caster over
post on bottom of Dust Drum and press
firmly in place, as shown.
5. Repeat for the other three Caster/
Caster Foot assemblies.
6. Turn the Dust Drum upright.
Post
Dust
Drum
SP7053 HD1600M0 SE .indd 27
Caster
Caster Stem
Caster Ball
Caster
Foot
Caster Foot
Caster Foot
Post Hole
27
Wet/Dry Vac Assembly
Accessory Caddy Installation
1. Place the Two Tabs on the bottom
edge of the Accessory Caddy into the
Two Slots on the rear of the Dust Drum.
2. Pivot the top of the Accessory Caddy
upward until the Two Locking Tabs
engage the upper slots in the Dust
Drum. Press in on the top edge of the
Accessory Caddy until it snaps into
place. Check that the Locking Tabs
are securely locked by pulling outward
on the Accessory Caddy.
ASSEMBLED
Locking
Tabs (2)
Accessory
Caddy
Dust Drum
10/4/18 10:03 AM