Buffalo WMBR-HP-GNV2 User Manual page 28

Broadband adsl2+ modem router
Table of Contents

Advertisement

Chapter 4 Configuration
Parameter
User Name
Password
Connect on Demand/Keep Alive
Host Name
Domain Name
MTU
Network Setup
Local IP Address / Subnet Mask
Local DHCP Server
WBMR-HP-GNV2 User Manual
Meaning
Set the user name (PPP login name) specified by the provider in 64
or less single-byte alphanumeric characters and symbols.
If the name specified by the provider contains an @ mark, the
characters after the @ mark cannot be omitted when entering the
User Name.
Set the password specified by the provider in 64 or less single-byte
alphanumeric characters and symbols.
Select the Connect on Demand or Keep Alive.
When Connect on Demand is selected, the AirStation is
automatically connected to the server only when communication is
performed. The connection is disconnected if the communication is
not performed for a preset time (disconnect time).
Set the disconnect time in the range from 1 to 9999 minutes.
When Keep Alive is selected, the AirStation issues an LCP echo
request to the server periodically at preset time intervals, and
the response received from the server is used to confirm that
communication is enabled.
If no response from the server is received, the AirStation assumes
that the line is disconnected, and it disconnects the connection.
Set the Keep Alive time interval in the range from 20 to 180
seconds.
Set the host name that is sent to the server when acquiring the IP
address from the Internet.
Set the domain name.
Set the MTU (Maximum Transmission Unit) that is used in
communication.
Select from Auto or Manual. When set to Manual, the available
range is set from 576 to 1500 bytes.
By default, the LAN side IP address is 192.168.11.1 with subnet
mask 255.255.255.0. You may change it here.
The factory setting of this control, Enable, sets the gateway to act
as a DHCP server for local machines. When this setting is used, you
can set a range of IP addresses to be assigned by DHCP. Addresses
outside this range can be assigned manually to machines set to use
fixed IP settings.
27

Advertisement

Table of Contents
loading

Table of Contents