Advertisement
Making changes to Installer Setup and performing Installer Test
Follow these steps to set system options after initial installation.
NOTE:
Use a USB device to save set up time. See page 14.
1 Touch Menu.
Installer
2 Select
3 Enter password (date code) and
touch Done.
Create Setup
4 Select
5 Follow prompts on the screen to
select the desired setup options or
to perform an equipment test.
Mounting outdoor and indoor sensors
Mounting an outdoor sensor
1 Mount the sensor on a vertical
exterior wall, at least 6 inches below
any overhang. Choose a location
protected from direct sunlight.
2 Place sensor securely in bracket,
facing away from wall.
69-2739_A.indd 12
Options.
Installer
Test.
or
Installer Op�ons
12
Done
11/1/2012 2:33:33 PM
Advertisement
