Removing/Installing The Metal Handle - RIDGID WD1956M1 Owner's Manual

SP6731-6 16 Gallon ESF 2018.qxp_SP6731 2/21/18 8:14 PM Page 6

Removing/Installing the Metal Handle

Your Metal handle comes packaged in
the carton in the reverse direction.
You must pull the metal handle
completely out of Vac and reinstall the
handle in the correct direction, bent area
facing away from the back of the Vac,
before continuing.
Installing Handle
Press and hold release buttons while
installing handle into handle receptacles
in drum (See illustration).
NOTE: An audible snap of release
buttons indicates successful engagement
of handle.
Lowering Handle for Storage
To store Wet/Dry Vac, press and hold
release buttons while firmly sliding handle
down.
Removing Handle
Press and hold release buttons, as
shown. While firmly pushing in release
buttons, pull handle upwards to remove
(see illustration).
Installing Tool Holder
Install tool holder as shown with
extension wand holders facing unit.
Tote Snaps
Correct
Position
Tote
Straps (5)
Handle
Extension
Wand
Storage
Locations
6
Metal Handle in
Reversed Position
(As Shipped)
Moving
Position
Storage
Position