Makita CG100D Instruction Manual page 10

Overload warning lamp
► Fig.6: 1. Warning lamp
The warning lamp blinks when the tool is highly loaded.
If the load increases and the tool becomes overloaded,
the tool stops automatically and the warning lamp keeps
on lighting. In this case, release the switch trigger, and
remove the cause of overload, and then restart the tool.
NOTE: When the warning lamp blinks, check the
following points:
• The caulking material is clogged.
• The speed adjusting dial is set to high speed.
• The cutting area of the tip of the cartridge nozzle
or film type package is too small.
Drip preventive function
The motor keeps running for a short time even after the
trigger is released. It releases the pressure of the caulk-
ing material and prevents dripping.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
Always place the tool on the
ground or workbench when carrying out any
assembling work. The tool without being held tight
may lose balance and cause injury.
Parts preparation
Optional accessory
The tool is composed of the following attachment parts
as shown in the illustration.
► Fig.7: 1. Holder joint 2. Plate 3. Piston 4. Holder
5. Rubber ring 6. Nozzle 7. Holder joint (as a
cap) 8. Rod
NOTE: Some attachment parts or optional accesso-
ries are not available in your country.
Prepare the proper type of attachment parts depending
on the caulking material container by referring to the
following table.
- 300 ml
Holder
joint
Holder
joint A
Plate
Rod
Short rod
Piston
Holder
Holder A
Rubber
ring
Nozzle
(Use the nozzle which is attached to the cartridge)
Holder Not
joint required
(as a
cap)
10 ENGLISH
Cartridge
400 ml 600 ml
Holder joint B
Holder joint C
(Holder joint
Plate
Long rod
Piston A
Holder D
Holder B
Not required
Not required
Holder joint B
Holder joint C
800 ml
complete
C + Plate)
Black rod
Piston D
Holder C