General Assembly - RIDGID AC9910 Owner's Manual

Planning for Non- RIDGID Tools
Other bench top power tools may be
mounted on this legset. However, first
make sure:
• The benchtop power tool does not
weigh more than 300 pounds and is
evenly distributed on the particle board
table top.

General Assembly

Attaching Leveling Feet
1. Locate the following parts and hard-
ware.
8 Hex Jam Nuts, 3/8-16
4 Leveling Feet
4 Lower Legs
2. Thread hex nut to within 1/4 inch of the
bottom of each of the four leveling feet.
3. Install leveling feet through holes in
lower legs as shown. Finger tighten
nuts.
4. Final adjustment and tightening of the
leveling feet will be needed once you
have completed the entire assembly
process.
• The benchtop power tool is securely
fastened to the particle board top.
• The combined legstand and attached
bench top power tool are stable and
will not tip.
If your tool is similar to one of the above,
use that setup configuration.
Hex Jam Nut
3/8-16
8
Leveling
Foot
Lower Leg
Leveling
Foot