Makita PB002G Instruction Manual page 8

Lighting up the front lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp goes out approximately 10 seconds after
releasing the switch trigger.
Fig.5
► 1 . Lamp
NOTE: Do not apply impact to the lamp, which may
cause damage or shorted service time to it.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
NOTE: When the tool is overheated, the lamp blinks
for one minute, and then goes off. In this case, cool
down the tool before operating again.
Hook
CAUTION:
Never hang the tool at high or
potentially unstable location.
CAUTION:
Use the hanging/mounting parts
for their intended purposes only. Using for unin-
tended purpose may cause accident or personal
injury.
The hook is convenient for hanging the tool temporarily.
To use the hook, simply lift up hook until it snaps into
the open position.
When not in use, always lower hook until it snaps into
the closed position.
Open position
Fig.6
► 1 . Hook
Closed position
1
Fig.7
► 1 . Hook
ASSEMBLY
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing the band saw blade
cause the blade to slip or come off unexpectedly.
Wipe off all excess oil with a cloth before install-
ing the band saw blade.
when handling the band saw blade.
band saw blade to avoid cut by the sharp edge of
the blade teeth.
the band saw blade when checking the blade
movement.
lever clockwise to release the tension on the band
saw blade, point the tool downward because the
band saw blade may come off unexpectedly.
8 ENGLISH
CAUTION:
Always be sure that the tool is
CAUTION:
Oil on the band saw blade can
CAUTION:
Always wear protective gloves
CAUTION:
Use caution when handling the
CAUTION:
Keep your body away from
CAUTION:
When turning the blade tightening
1
1