Table of Contents
Advertisement
3.3 Factory Setting
The calibrator is factory configured to:
•
•
•
•
3.4 Battery Installation or Replacement
3.4.1
3.4.2
3.4.3
3.4.4
3.4.5
If you see (LO-BAT) in the upper left of the LCD,
the battery voltage is 5.2 Volts or less. It is time to
replace the battery.
I
NSTALLATION AND
1XXX.0 decimal point location
No dummy zero
2.5 Volt Transducer excitation
3 mV/V sensitivity
If any of the previous characteristics do not suit
your application, follow steps in Section 4 of this
manual to reconfigure to your needs.
Turn off the calibrator.
Remove the battery compartment door located on
the rear of the unit, sliding the door in the direction
of the arrow.
Remove the battery from the compartment and
carefully remove it from the battery clip. Do not pull
on the wires on either end.
Attach a new battery to the battery clip observing
polarity and place the battery back into its recess in
the case.
Replace the battery compartment door.
O
PERATION
3
7
Advertisement
Table of Contents
