Cisco 3110 Hardware Installation Manual page 82

Secure the Power Cord on the Power Supply Module
b) Plug the snapping portion of the tie wrap into the hexagonal hole.
c) With the clamp side facing up, push the tie wrap in until it is fully engaged.
Make sure you have the correct location because you cannot remove the tie wrap from the power supply
Caution
module once you have installed it without damaging the tie wrap.
Figure 54: Connect the Tie Wrap
1 Tie wrap
Step 3
Secure the clamp:
a) Plug in the power cord into the power supply module and wrap the clamp around the over mold portion of the power
cord.
b) Squeeze the clamp ends together so that the annular teeth engage with the mate on the clamp.
c) Make sure the clamp fits snugly into the over mold.
d) Adjust the clamp position on the tie wrap so that the clamp is tight against the front of the over mold and the power
cord cannot be removed by lightly pulling on it.
Cisco Secure Firewall 3110, 3120, 3130, and 3140 Hardware Installation Guide
78
Installation, Maintenance, and Upgrade
2 Hexagonal hole