Deployment Options - Cisco 3110 Hardware Installation Manual

Deployment Options

Feature
Storage
Pullout asset card
Grounding lug
Power switch
Reset button

Deployment Options

Here are some examples of how you can deploy the Secure Firewall 3100:
• As a firewall:
• As a device that provides additional application control, URL filtering, or IPS/threat-centered capabilities:
• As a branch native SD-WAN solution that offers remote deployment and is managed over a 4G LTE
• As a VPN device:
Cisco Secure Firewall 3110, 3120, 3130, and 3140 Hardware Installation Guide
4
3110
Two Nonvolatile Memory Express (NVMe) SSD slots
Ships with one 900-GB SSD installed in slot 1. You can order a second RAID1 SSD
for slot 2. The RAID1 SSD is preconfigured for RAID1.
Slot 2 is reserved for the optional software RAID1 configuration.
Note
Hot-swapping is supported with 2 SSDs. However, you must enter a CLI
Note
command to remove one disk from the RAID before hot swapping. See the
CLI configuration guide for your software for the procedure.
Displays the serial number and a QR code that points to the low touch provisioning
(LTP) guide.
On rear panel
On rear panel
Resets the system to factory default without requiring serial console access
The reset button is recessed. Press with a pin and hold longer than 5 seconds
Note
to set the system back to the factory default.
• At the enterprise internet edge in a redundant configuration
• At branch offices in either a high availability pair or standalone
• At data centers in a high availability pair or clustered, which serves the needs of smaller enterprises
• Behind an enterprise internet edge firewall in an inline configuration or as a standalone (requires
hardware fail-open network module support)
• Deployed passively off a SPAN port on a switch or a tap on a network, or standalone
• For remote access VPN
• For site-to-site VPN
3120 3130
Overview
3140