Honeywell T2 Quick Start Manual

Dimensional drawings:
Wall mounting installation:
1
C
B
Step 1. With the screws properly fastened, drill one of the holes A, B or C (fig. 1). If you choose hole A or B
the drill size must be 12 Ø and place the glands. If you choose hole C you can drill pattern of the
hole. Follow the same step for the other side of the device.
Step 2. Unfasten the 2 screws (fig. 2) and remove the front cover.
Step 3. Drill the 2 holes (fig. 3) and use the mounting accessories to mount the device.
Step 4. Install the cables (and the glands if needed) and perform the electrical connections. (NOTE: Use
1 power input only, either 230 VAC or 24 VDC.)
Step 5. Reinstall the removed parts of step 2 and power on the device.
Installation on a DIN-rail:
1
In case you want to install the device without the including box:
Step 1. Pull the mounting clips to open and mount the device on the DIN rail.
Step 2. Install the cables and perform the electrical connections.
(NOTE: Use 1 power input only, either 230 VAC or 24 VDC.) Power on the device.
Honeywell Life Safety AS, Postboks 263, 1372 Asker
2
A
Wireless
I/O Unit T2
70mm
3
2
60mm
4
NC NO NC C NO IN2 IN1
http://www.hls-nordic.com
GB
NC
NO NC C NO IN2 IN1