Wan - D-Link DPN-101G User Manual

Section 3 - Configuration
Choose WAN > PON WAN. The WAN tab that is displayed. In this page, you can configure WAN interface of your router.
The following table describes the parameters of this page:
Field
Enable VLAN option, you will need to config the
VLAN ID and 802.1p_Mark.VLAN ID is from 1~4095,
VLAN
but some of it is in reserved. 802.1p is the priority
from 0~7.
You can choose Bridged, IPoE, PPPoE. Bridged is
for forwarding data under layer-2 network. Usually
user need to connect another router on the LAN
Channel Mode
side. IPoE is for obtain IP from ISP or configure IP
manually. PPPoE is configured to PPP dial-up.
From Channel Mode, you can configure bridged
mode or routed mode. If you configured routed
Enable Bridge
mode, you can also enable this option to let
bridged mode works simultaneously.
Under routed mode, user can enable this option to
Enable NAPT
use NAT or not.
This option is always set to Enable to enable
Admin Status
service.
After your change please press "Apply Changes" to change.
D-Link DPN-101G User Manual

WAN

Description
12