Honeywell CT40 User Manual page 51

Setting
Data Intent
Symbology Settings
Use the Symbology Settings to enable or disable barcode symbologies for the
selected scan setting profile.
•
•
To view a list of default settings for supported symbologies, see
Decode Settings
Adjust the Decode Settings when scanning barcodes that are densely packed or
poor quality.
Decode Settings
Setting
Center Decode
Decode Security
Decoder timeout
CT40/CT40 XP Mobile Computer Series User Guide
Description
Enables the reception and processing of barcode data
without using an SDK or library.
Tap the check box next to a symbology name to enable (check mark) or disable
(no check mark) decoding for that symbology.
Tap the symbology name to view and modify additional configuration
parameters for the symbology selected.
Description
When enabled, the imager scans and decodes a barcode only if
part of the barcode is at the center of the aimer window. This is
useful in situations where several barcodes may be very close
together in the imager field-of-view.
•
•
•
•
•
•
Use this setting to control the reading tolerance of the decoder.
Lower settings are more lenient when reading low quality barcodes
while higher values are more strict.
Set the amount of time in seconds that the scanner will timeout if a
readable barcode is not found.
Tap the check box to toggle the feature on or off.
Select Center Decode to adjust the Window dimensions.
Honeywell recommends leaving the settings at 50
(default) to define the "center" area for the barcode.
Configurable parameters:
Window top
Window bottom
Window left
Window Right
Default
Disabled
page 98.
Default
Disabled
2
150
41