Equalizer Level Adjusting; Spectrum Analyzer Display Selection - Kenwood DPX-4010 Instruction Manual

Preset Equalizer Selection
You can choose the equalizer from four settings whose sound
qualities are preset to match music or vehicle characteristics.
Switching the Preset Equalizer:
1
Press the EQ button.
"EQ mode" is displayed once the equalizer mode is entered.
2
Each time you press the EQ button, the preset equalizer
switches as follows;
3 "Rock" 3 "Pops" 3 "Vocal" 3 "Heavy" 3 "Flat"
3
Press the EQ button for at least one second to end the
equalizer mode.
NOTE
If you make no button operation for 10 seconds, the equalizer
mode is automatically canceled.

Equalizer Level Adjusting

You can adjust the level of the equalizer effects.
1
Press the EQ button.
"EQ mode" is displayed once the equalizer mode is entered.
2
Each time you press the AM or FM button, the equalizer
effects switch as follows;
3 3
"LOW" "MID" "HIGH"
2 2
NOTE
• This adjustment cannot be made when the Preset Equalizer
Selection is set to "Flat".
• The default setting is "MID".
3
Press the EQ button for at least one second to end the
equalizer mode.
NOTE
If you make no button operation for 10 seconds, the equalizer
mode is automatically canceled.

Spectrum Analyzer Display Selection

You can select the display to enjoy sounds with eyes.
Switching the Spectrum Analyzer Display:
1
Press the S.A button.
"SPEANA mode" is displayed once the analyzer mode is
entered.
2
Each time you press the S.A button, the analyzer display
switches as follows;
The spectrum analyzer display switches in
"SPEANA scan"
sequence for 10 secconds each.
"Peak Hold"
"Squall"
"Catcher"
"Level Meter"
"Rolling Bar"
"Stream"
"Radar"
"Falling Star"
"Music Scope"
3
Press the S.A button for at least one second to end the
analyzer mode.
NOTE
If you make no button operation for 10 seconds, the analyzer
mode is automatically canceled.
— 23 —