Switching Modes; Audio Control Setting - Kenwood DPX-4010 Instruction Manual

General features

Switching Modes

Switching Modes:
Each time you press the SRC (source) button, the mode
switches as follows:
Tuner mode
Tape mode
CD mode
External disc control mode 1
External disc control mode 2/AUX mode
Standby mode
Selecting standby mode:
Press the SRC button repeatedly and switch to "ALL OFF" .
When "ALL OFF" is displayed, the standby mode is activated.
The standby mode turns all functions off while leaving the
power to the unit on. Use this mode when you want to have
the display illuminated but don't want to listen to anything.
NOTE
• The mode switches to the next mode from any mode which
cannot be used.
• The external disc control mode will differ depending on the unit
that is connected.
• The AUX mode is available only when the changer / AUX
switching adapter (KCA-S210A or CA-C1AX) or CD changer
(KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is
connected to this unit.
During the AUX mode, "AUX INPUT" will show in the display.
When the CA-C1AX is being used, the AUX Mode will replace
the External Disc Control Mode.

Audio Control Setting

Adjust various parameters of sound quality.
1
Press the AUD button for at least one second to enter the
control mode.
2
Selecting mode
Press either the 4 or ¢ button.
Each time the button is pressed, the adjustment mode will
change.
Please refer to the following for the contents of the
adjustment modes.
3
Adjust each mode
Press the FM/AM button.
Please refer to the following for the adjusting values.
4
Press the AUD button for at least one second to end the
control mode.
"Balance" : Adjust the balance level.
Setting values: Left 15 – Right 15
"Fader" : Adjust the fader level.
Setting values: Front 15 – Rear 15
"NON FAD" : You can set the non-fading sound output to either
on or off.
Setting values: "NON FAD On" (ON) – "NON FAD Off" (OFF)
NOTE
This mode is available only when the non-fading output function
is set to on.
— 8 —