Switching Display For Tuner - Kenwood DPX-4010 Instruction Manual

Alphabet (upper case)/Numerals/Symbols:
A ~ Z 0~9 / + – * = < > [ ]
Alphabet (lower case)/Numerals/Symbols:
a ~ z 0~9 / + – * = < > [ ]
5
Continue steps 3 and 4 until all the characters are chosen for
the name.
NOTE
You can enter up to 8 characters for each name.
6
Assigning Names
Press the NAME.S button.
The name of the station is stored in memory, and the Station
Name Preset mode ends.
Also, if you make no input for 10 seconds, the name will be
stored up to the point that you have entered, and the mode
ends.
NOTE
• You can assign names to up to 30 FM/AM stations in all.
If you try to enter more than that, the station name stored the
earliest will be the first one erased.
• If you want to change the name of a station, first display the
name of the station (following steps 1 and 2 above), then
change the letter(s) that you want by following steps 3 and 4.

Switching Display for Tuner

You can change the display used when listening to the radio.
Changing the Display:
Each time you press the DISP button, the display changes as
follows:
Station frequency
SNPS name (only when being preset)
Character
Clock
— 11 —