Makita DUB142 Instruction Manual page 4

Switch action
CAUTION:
• Before inserting the battery cartridge into the
tool, always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released.
3
► 1. Pointer 2. Air volume adjusting dial 3. Switch
trigger
To start the tool, simply pull the switch trigger. Air vol-
ume is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
Air volume adjusting dial
Air volume can be adjusted to any of three settings by
turning the adjusting dial with the switch trigger fully
depressed. Refer to the table below for the relationship
between the number on the dial and the air volume.
Number on the dial
3
2
1
CAUTION:
• Use the adjusting dial only after the switch
trigger returns to the "OFF" position. Turning the
dial before the trigger returns may damage the
tool.
• If the tool is operated continuously until the
battery cartridge has discharged, rest the tool
for at least 15 minutes before proceeding with a
fresh battery.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
1
2
Air volume
High
Medium
Low
4 ENGLISH
Blowing
1
► 1. Nozzle 2. Blower outlet
For dust blowing, attach nozzle to blower outlet, turning
clockwise to lock it in place.
To remove the nozzle, turn it counterclockwise.
Dust suction
1
3
4
► 1. Dust bag 2. Blower outlet 3. Suction inlet
4. Nozzle
For dust suction, fit nozzle onto suction inlet and dust
bag onto blower outlet.
After the bag fills with dust, empty the contents of the
dust bag into a dust bin by releasing the fastener.
► 1. Fastener
CAUTION:
• Empty the dust bag before it becomes too full, or
the suction force weakens.
2
2
1