Table of Contents
Advertisement
Adjusting the motor height
1
006824
Loosen the knob and turn the crank handle to raise or
lower the motor. After obtaining the desired height,
always retighten the knob to secure the motor.
OPERATION
1
2
3
4
006826
Grip the workpiece in the vise. Use spacer blocks or
pieces of scrap to prevent deformation of the aluminum
workpiece if necessary. Operate the two feed handles
when cutting the workpiece. For better cutting action,
coat the aluminum workpiece with the oil provided.
CAUTION:
Never apply the oil when the bit is rotating.
•
When cutting rectangular cutouts, proceed as follows.
1.
Hold the crank handle with your right hand and
loosen the knob with your left hand.
2.
Hold the transvers feed handle with your left hand
so that the table (bed) does not move. Turn the
crank handle to drill a hole in the workpiece.
3.
Tighten the knob to secure the motor in this
position. Then operate the two feed handles to cut
the rectangular cutouts.
Angle gauge
006827
1. Knob
2. Thumb screw
3. Crank handle
2
3
1. Chip guard
2. Workpiece
7
3. Transverse feed
6
handle
4. Longitudinal
feed handle
5. Table
5
6. Vise
7. Crank handle
1. Wing nut
2. Angle gauge
1
2
Use the angle gauge for the angle work. Secure it to the
table (bed) using the wing nut. Then fasten the workpiece
in position as shown in the figure. If the workpiece is big
or long, remove the chip guard (chip deflector).
Adjusting for smooth motor travel
006828
If the motor does not travel smoothly, proceed as follws.
1.
Loosen the screw (A).
2.
Tighten the screw (B) (2 pcs.) evenly until you
cannot turn the crank handle easily.
3.
Tighten the screw (A) until you can turn the crank
handle smoothly.
NOTE:
Clean the contacting portions and occasionally
•
lubricate them.
Adjusting for smooth table (bed) travel
006829
If the table (bed) does not travel smoothly in the
longitudinal
direction,
accordingly.
Using as a trimmer
1. Trimmer base assembly (optional accessory)
2. Motor
3. Trimmer
006830
To use as a trimmer, remove the motor from the tool and
attach the trimmer base assembly (optional accessory)
to the motor as shown in the figure.
5
1. Screw (A)
1
2. Screw (B) (2
pcs.)
3. Crank handle
2
3
1. Brake screw
1
tighten
the
brake
screw
Advertisement
Table of Contents
