Table of Contents
Advertisement
4.
Check the bit carefully for cracks or damage
before
operation.
damaged bit immediately.
5.
Avoid cutting nails. Inspect for and remove all
nails from the workpiece before operation.
6.
Hold the tool firmly.
7.
Keep hands away from rotating parts.
8.
Make sure the bit is not contacting the
workpiece before the switch is turned on.
9.
Before using the tool on an actual workpiece,
let it run for a while. Watch for vibration or
wobbling
that could
installed bit.
10. Be careful of the bit rotating direction and the
feed direction.
11.
Do not leave the tool running. Operate the tool
only when hand-held.
12. Always switch off and wait for the bit to come
to a complete stop before removing the tool
from workpiece.
13. Do not touch the bit immediately after
operation; it may be extremely hot and could
burn your skin.
14. Always lead the power supply cord away from
the tool towards the rear.
15. Do not smear the tool base carelessly with
thinner, gasoline, oil or the like. They may
cause cracks in the tool base.
16. Draw attention to the need to use cutters of
the correct shank diameter and which are
suitable for the speed of the tool.
SAVE THESE INSTRUCTIONS.
Replace
cracked
indicate improperly
FUNCTIONAL DESCRIPTION
or
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Switch action
1
006614
CAUTION:
Before plugging in the tool, always be sure that the
•
tool is switched off.
To start the tool, move the switch lever to the I (ON)
position. To stop the tool, move the switch lever to the O
(OFF) position.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing the bit
1
006823
CAUTION:
Use only the wrenches provided with the tool.
•
Do not tighten the collet nut without inserting the bit.
•
The collet cone will break.
Insert the bit all the way into the collet cone and tighten
the collet nut securely with the two wrenches.
To remove the bit, follow the installation procedure in
reverse.
4
1. Switch lever
1. Wrench 10
2. Wrench 17
3. Tighten
2
4. Loosen
Advertisement
Table of Contents
