Winding Thew Bobbin - AEG 225/7 LCD Instruction Book

WINDING THE BOBBIN
Spindle
Correct
Screw
8
Clutch button
5 cm thread
1. For bobbin winding push the knob in the
handwheel towards the bobbin symbol, in
order to stop the needle movement while
winding and lead the thread from the spool
through the bobbin winder tension disc.
2. Now pull the end of the thread about 5 cm
through the hole in the bobbin from the
inside to the top. Place the bobbin on the
bobbin winder and push the bobbin winder to
the right.
3. Hold the end of the thread and step on the
foot controller. As soon as the bobbin is
wound with the thread a few times let the
end of the thread go. Cut the excess thread
close to the bobbin and wind the bobbin.
4. When winding is finished, push the knob in
direction of needle symbol to get contact.
Push bobbin winder spindle in direction of the
arrow. When bobbin winding is completed, return
spindle to its original position.
When bobbin winding is uneven, release the
screw of the upper thread guide and adjust up or
down until bobbin the winding is balanced.