Remove The Pcie Riser Assembly - Lenovo ThinkSystem SR250 Setup Manual

Figure 44. Front operator panel removal
If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.

Remove the PCIe riser assembly

Use this information to remove the PCIe riser assembly .
Before you remove the PCIe riser assembly , complete the following steps:
1. Read the following section(s) to ensure that you work safely.
• "Installation Guidelines" on page 48
2. Turn off the server. Disconnect the power cords and all external cables (see "Power off the server" on
page 80).
3. If server is installed in a rack, remove the server from the rack.
4. Remove the top cover (see "Remove the top cover" on page 52).
To remove the PCIe riser assembly , complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
UCjqE4XzuvdHpVM9lXt41M8g/playlists
Step 1. Grasp the PCIe riser assembly by its edges and carefully lift it out of the server.
Notes:
1. The following illustration might differ slightly from your hardware.
2. Carefully lift the PCIe riser assembly straight up. Avoid tilting the PCIe riser assembly at a large
angle, tilting might cause damage to the connector.
ThinkSystem SR250 Setup Guide
56
https://www.youtube.com/channel/
.