GE JGRS06BEJ Installation Instructions Manual
24” gas built-in oven
Hide thumbs
Also See for JGRS06BEJ:
- Dimensions and installation information (2 pages) ,
- Owner's manual (37 pages)
Table of Contents
Advertisement
Available languages
Available languages
Quick Links
Download this manual
See also:
Owner's Manual
Installation
Instructions
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.GEAppliances.com
BEFORE YOU BEGIN
Read these instructions and warnings
completely and carefully.
IN THE COMMONWEALTH OF
MASSACHUSETTS:
• This product must be installed by a licensed
plumber or gas fitter.
• When using ball-type gas shut-off valves,
they shall be the T-handle type.
• A flexible gas connector, when used, must
not exceed 3 feet.
IMPORTANT
•
instructions for local inspector's use.
IMPORTANT
•
governing codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these
instructions for future reference.
• Skill level – Installation of this appliance
requires basic mechanical skills.
• Completion time – 1 to 3 hours
• Proper installation is the responsibility of
the installer.
• Product failure due to improper installation
is not covered under the Warranty.
WARNING
be properly grounded.
4053P579
229C
31-10585
12-03 JR
— Save these
— Observe all
— This appliance must
24" Gas Built-In Oven
JGRS06
FOR YOUR SAFETY:
WARNING
in this manual is not followed exactly, a fire,
explosion, or gas leak may result, causing
property damage, personal injury or death.
DO NOT STORE OR USE GASOLINE OR
OTHER FLAMMABLE VAPORS AND LIQUIDS
IN THE VICINITY OF THIS OR ANY OTHER
APPLIANCE!
WHAT TO DO IF YOU SMELL
GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not
use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call
the fire department. Installation and service
must be performed by a qualified installer,
service agency or the gas supplier.
• Be sure your oven is installed properly by
a qualified installer or service technician.
• Be sure the oven is securely installed in a
cabinet that is firmly attached to the house
structure. Weight on the oven door could
cause the oven to tip, resulting in serious
personal injury or death. Never allow
anyone to climb, sit, lean, stand or hang
on the oven door.
1
— If the information
Advertisement
Table of Contents
Related Manuals for GE JGRS06BEJ
Summary of Contents for GE JGRS06BEJ
- Page 1 Installation Instructions Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.GEAppliances.com BEFORE YOU BEGIN Read these instructions and warnings completely and carefully. IN THE COMMONWEALTH OF MASSACHUSETTS: • This product must be installed by a licensed plumber or gas fitter.
-
Page 2: Prepare To Install The Oven
National Energy Conservation Policy Act of 1978 and the National Appliance Energy Conservation Act of 1987. If the oven is to be installed in a mobile home, the installation must conform to the Manufactured Home Construction and Safety Standard, Title 24, CFR, Part 3280 or,... -
Page 3: Prepare The Opening
(See Fig. 2) It’s best to use a template to make a straight cut. Place the template on a level base line, 22″ to 28″ above the floor. This will place the oven cavity 36″ or 42″ above the floor. 24″... -
Page 4: Install The Oven
INSTALL THE OVEN ELECTRICAL CONNECTIONS An adequate electrical supply and outlet must be used to operate the electrical parts of your oven. The oven cord has a three-prong plug and must be used with a properly grounded three-hole outlet with a standard 120 Volt, 60 cycle AC household current. -
Page 5: Check For Leaks
Installation Instructions GAS CONNECTIONS (cont.) Place the oven in the cutout. Level the oven: 1. Place a spirit level on one of the oven racks. 2. If the oven is not level, adjust the leg levelers. With the oven in place, remove the regulator cover by carefully grasping the left side and pull until the spring clip is released. - Page 6 To properly check the burner, the oven bottom and oven baffle must be removed. Turn on bake or broil. As you watch the flame with the oven door closed, check the following through the oven door window: 1. Burner flames should not flutter or blow away from the burner.
- Page 7 WARNING: If you are using L.P. (bottled) gas, all the adjustments described below must be made before you make any burner adjustments or use the oven. WARNING: This conversion must be performed by a qualified installer or gas supplier in accordance with the manufacturer’s instructions and all codes...
- Page 8 NOTE: The oven burner flame must be checked with the door closed to properly check flame characteristics. Turn on bake or broil. As you watch the flame with the oven door closed, check the following through the oven door window: Burner flames should not flutter or blow away from the burner.
-
Page 9: Antes De Empezar
Instrucciones de Instalación ¿Preguntas? Llame al 1.800.GE.CARES (800.432.2737) o bien visite nuestra página Web: www.GEAppliances.com ANTES DE EMPEZAR: Lea estas instrucciones y las advertencias completa y cuidadosamente. EN LA MANCOMUNIDAD DE MASSACHUSETTS: • Este producto debe ser instalado por un plomero licenciado o por un técnico de gas. - Page 10 Instrucciones de Instalación PREPARACIÓN PARA INSTALACIÓN DEL HORNO LISTA DE HERRAMIENTAS Taladro con Punta de 1/8″ Gafas de Seguridad Llave inglesa ajustable Llave inglesa para cañerías Nivel de espíritu de 12″ Soquete hexagonal de 3/16″ Destornillador Phillips No. 1 o No. 2 MATERIALES ADICIONALES QUE PODRÍA NECESITAR: Válvula de cierre...
-
Page 11: Notas Especiales
Instrucciones de Instalación PREPARACIÓN DE LA ABERTURA Espacio del gabinete: 24″ mín. de profundidad 24″ mín. de anchura Abertura: 22 3/16″ de anchura 38″ de altura 3/8″ mín. en ambos lados (Vea Fig. 2) Es buena idea usar un modelo para hacer un corte derecho. -
Page 12: Instalación Del Horno
Instrucciones de Instalación INSTALACIÓN DEL HORNO CONEXIONES ELÉCTRICAS Un abastecimiento y receptáculo eléctrico adecuado debe ser usado para operar las partes eléctricas de su horno. El cordón del horno tiene un enchufe de tres patas y debe ser usado con un receptáculo de tres hoyos que haga tierra adecuadamente con corriente alterna normal de casa de 120 Voltios, 60 Ciclos. - Page 13 Instrucciones de Instalación CONEXIONES DEL GAS (cont.) Coloque el horno en el corte. Nivele el horno: 1. Coloque el nivel de espíritu sobre una de las parrillas del horno. 2. Si el horno no está nivelado, ajuste los niveladores de las patas. Con el horno en su lugar, saque la cubierta de regulador tomando cuidadosamente el lado izquierdo y tirando hasta que el gancho se suelte.
- Page 14 Instrucciones de Instalación INSTALACIÓN DEL HORNO CÓMO REVISAR LAS LLAMAS DE LOS QUEMADORES A GAS NATURAL El horno viene ajustado de fábrica para ser usado con gas natural en la mayoría de las áreas. Pero, como el gas en algunas áreas varía, usted debe revisar todos los ajustes que se describen más abajo.
- Page 15 Instrucciones de Instalación CÓMO HACER LA CONVERSIÓN PARA GAS L.P. ADVERTENCIA: a usar gas L.P. (embotellado), todos los ajustes descritos más abajo deben hacer antes de hacer cualquier ajuste a los quemadores o usar el horno. ADVERTENCIA: debe ser hecha por un instalador competente o por el abastecedor de gas de acuerdo con las instrucciones del fabricante y todos los códigos y requerimientos de las autoridades que tienen...
- Page 16 Instrucciones de Instalación CÓMO HACER LA CONVERSIÓN PARA GAS L.P. AJUSTE EL OBTURADOR DE AIRE NOTA: Las llamas para hornear y asar se deberían revisar con la puerta cerrada para revisar correctamente las características de la llama. Encienda el quemador para hornear y para asar. Mientras mira la llama con la puerta cerrada, revise lo siguiente a través de la ventana de la puerta: Las llamas del quemador no deberían pestañear...