Advertisement
1.
Fasten the sounder to the wall.
2.
Insert the connection cables through the holes located on the base.
3.
If required, modify the default settings by adjusting the dip switches as indicated in the charts above.
4.
Connect the power supply to the control panel.
5.
Close the internal and external covers with the screws provided.
WARNING: The power supply must be of SELV type.
Note: to avoid formation of condensation inside the sounder, any air flow must be avoided. Once the cables have
been connected, seal the hole using some silicone. This operation will prevent the warm and humid air of the
building from forming condensation inside the sounder during winter time, thus avoiding the risk of
malfunctioning.
SOUNDER INSTALLATION
Advertisement
