Yamaha F300A Owner's Manual page 49

engine overheating. If the engine is mounted
too low, water resistance (drag) will in-
crease, thereby reducing engine efficiency
and performance.
Most commonly, outboard motor should be
mounted so that the anti-cavitation plate is in
alignment with the bottom of the boat. The
optimum mounting height of the outboard
motor is affected by the boat/motor combina-
tion and the desired use. Test runs at differ-
ent heights can help determine the optimum
mounting height. Consult your Yamaha deal-
er or boat manufacturer for further informa-
tion on determining the proper mounting
height.
ECM01630
NOTICE
During water testing, check the buoy-
G
ancy of the boat, at rest, with its maxi-
mum load. Check that the static water
level on the exhaust housing is low
enough to prevent water entry into the
power head when water rises due to
waves when the outboard is not run-
ning.
Incorrect engine height or obstructions
G
to the smooth flow of water (such as the
design or condition of the boat, or ac-
cessories such as transom ladders or
depth finder transducers) can create
airborne water spray while the boat is
cruising. If the motor is operated con-
tinuously in the presence of airborne
water spray, enough water could enter
the engine through the intake opening
on the cowling to cause severe engine
damage. Eliminate the cause of the air-
borne water spray.
ZMU01762
Installation
43