The User Program; Entering Programming Mode - GE DigitalFlow DF868 Programming Manual

March 2008

The User Program

Entering Programming
Mode
1-8
Use the keypad, as described in the previous section, to navigate
through the User Program. The menu map may be followed in
sequence, or the [↑] and [↓] keys may be used to scroll through the
prompt screens. The [←] key may be used to delete the last
alphanumeric character that was entered from the keypad.
The following discussion assumes that the left screen pane is active.
If the right screen pane is active, only the function key designations
change. That is, replace
Note: Be sure to record all the programming data entered in this
chapter in Appendix B, Data Records.
ACTIV
Programming of the
operation of the Model DF868. Failure to accurately enter all of the
required information will result in unreliable flow rate data.
Therefore, be sure to complete at least the sections of this chapter
pertaining to those three submenus.
Note: Because it is so essential, instructions for programming the
ACTIV SYSTM
, and
Startup Guide. If that programming has already been
completed, those sections of this chapter may be skipped.
Except for the three submenus noted above, it is not necessary to
program the Model DF868 flowmeter in any particular order.
Therefore, the sections of this chapter need not be completed in
sequence. Proceed immediately to any section of interest.
Note: To enter calibration data, please refer to Chapter 1,
Calibration, of the Service Manual.
To access the User Program, press the
standard measurement mode screen is replaced by the following
initial programming mode screen:
PROGRAM
PROGRAM
status
ACTIV SYSTM PIPE
Note: If the security feature is active, enter the password and press
[ENT]
the key to enter the User Program. See the
submenu section of this chapter for more information on the
security feature.
[F1]-[F4] [F5]-[F8]
with .
SYSTM PIPE
, and submenus is necessary for
PIPE
submenus are also included in the
[PROG]
key on the keypad. The
Start ‰ Press the [←] and [→] keys and
one of the function keys
to select the desired submenu.
From this screen, press
return to measurement mode.
I/O
Programming Site Data
[F1]-[F4]
[EXIT]
to
SECUR