Installation Guidelines; Connection Diagram; Bus-2 Connection; Mounting - Honeywell 013080 Mounting And Connection Instructions

18
7.

Installation guidelines

Observe the information for
i n s t a l l a t i o n i n t h e
installation instructions
manual for the control
panel
The BUS connecting cable
shielded, twisted pair line.
The corresponding line cross-sections
can be found in the installation
instructions manual of the intruder alarm control panel (see "Lines").
When BUS-2 actors are connected in series, the cable shield in the housing of the TouchScreen
ControlPanel must be connected to an appropriate terminal.
Keep the shield connections as short as possible to avoid the risk of short circuits, and insulate shield
wires using insulation tubing, for example.
Possible number of TouchScreen ControlPanel, which can be operated to a control panel:
- MB-12, 561-MB24/48/100.10/256 plus:
- MB-Secure:
8.

Connection diagram

8.1

BUS-2 connection

Shield
A
Connection "B"
B
must remain free!
GND
+UB
9.

Mounting

9.1

Overview of the assembly

The use of the universal back case, serves for
- surface mounting or
- for cavity wall mounting
of the TouchScreen ControlPanel.
For cavity wall mounting, 4 additional
mounting claws with screws are included with
the control panel.
After mounting the front unit with the
electronics is inserted and screwed in place
the rear panel of the unit.
For the different types of installation, please
refer to the following chapters!
Mounting and Connection Instructions MB TouchScreen ControlPanel
Operating unit
Data (A)
GND
+UB
must be a
Note: No end of line resistor may be attached to the BUS.
total max. 12
total max. 50, max. 10 per BUS-2 line
Shield
Data BUS-2
0 V
0 V
+12 V DC
BUS-2
The TouchCenter must not be used in
conjunction with the loop module BUS-2
(013220.07.10).
The terminal connection 1 and terminal connection 2
are connected in parallel.
Front device
with electronic
Panel
0 V
Data
+UB
Back case