Advertisement
from chemicals or oil that cause the insulation to
deteriorate. Avoid sharp bends. The power cable is less
flexible in low temperature environments.
6.
Secure the cable to the vehicle structure at approximately
one foot intervals, taking care not to over tighten, pinch
conductors, or penetrate the insulation.
7.
Connect the watertight connector end of the power cable to
the dock power connector by aligning the connector pins to
the power connector; push down on the watertight
connector and twist it to fasten securely.
8.
Secure the power cable to the VM3A using the strain relief
cable clamps.
9.
Place VM3A in the dock.
10. If using the Screen Blanking feature, install the screen
blanking box or switch. (Refer to the Thor VM3A User Guide,
available at
about the Screen Blanking box.)
11. Press the power switch on the back of the dock.
12. Press the power button on the front of the VM3A.
13. Configure the Auto-ON behavior.
www.honeywellaidc.com
for further information
Advertisement
