Honeywell ADEMCO 6160RF3 Installation And Setup Manual page 4

Keypad/transceiver

page of 4

/ 4
Bookmarks

TROUBLESHOOTING

The error messages listed in the following table cause the 6160RF to produce a single ding tone. The table describes the error

messages and the corrective actions.

Display

Low Bat (with

Low battery in the wireless device.

zone no.)

Open Ckt

No data is being received from the control panel.

1. The control panel does not see the 6160RF

Check 100

Receiver, or the Receiver is not functioning.

Check 1xx*

2. Another device on the keypad terminals is not

communicating to the control panel.

*xx= the device address of the receiver.

SPECIFICATIONS

Physical:

5-3/8" H x 7-3/8" W x 1-1/4" D

(137mm x 187mm x 32mm)

Wiring:

Refer to Table 1

Range:

200 ft (60.9 m) nominal

Frequency:

345 MHz

FOR DETAILS ON THE LIMITATIONS OF THE ENTIRE ALARM SYSTEM, REFER TO THE INSTALLATION AND SETUP GUIDE FOR THE CONTROL PANEL

BEING INSTALLED IN CONJUCTION WITH THIS DEVICE.

The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's Manual. Unauthorized changes

or modifications could void the user's authority to operate the equipment.

This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the following statement for your information:

This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer's instructions,

may cause interference to radio and television reception. It has been type tested and found to comply with the limits for a Class B computing device in accordance

with the specifications in Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• If using an indoor antenna, have a quality outdoor antenna installed.

• Reorient the receiving antenna until interference is reduced or eliminated.

• Move the radio or television receiver away from the receiver/control.

• Move the antenna leads away from any wire runs to the receiver/control.

• Plug the receiver/control into a different outlet so that it and the radio or television receiver are on different branch circuits.

• Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

This device complies with Part 15 of the FCC Rules, and RSS210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Cet appareil est conforme à la partie 15 des règles de la FCC & de RSS 210 des Industries Canada. Son fonctionnement est soumis aux conditions suivantes: (1)

Cet appareil ne doit pas causer d' interferences nuisibles. (2) Cet appareil doit accepter toute interference reçue y compris les interferences causant une reception

indésirable.

‡K0903V1?Š

K0903V1 2/06 Rev. F

Probable Cause

Current:

Display:

Sounder:

FEDERAL COMMUNICATIONS COMMISSION STATEMENTS

CLASS B DIGITAL DEVICE STATEMENT

INDUSTRY CANADA CLASS B STATEMENT

FCC/IC STATEMENT

WARRANTY INFORMATION