Honeywell ADEMCO 6160RF3 Installation And Setup Manual

GENERAL INFORMATION
The ADEMCO 6160RF keypad/transceiver is a combination unit that combines the functions of the following devices:
• 6160 Alphanumeric Addressable Keypad
• 5881H RF Receiver
• 5800TM Transmitter Module
The 6160RF Keypad/Transceiver may be used on any control panel that supports 5800 Series wireless devices (e.g., VISTA-10P,
VISTA-15P, and VISTA-20P).
FEATURES
• Supports wireless key transmitters (e.g.; 5834-4) and bi-directional transmitters (e.g.; 5804BD, 5828/5828V).
• Supports wireless keys with high-security (encryption) capability (e.g.; 5804E, 5834-4).
• Provides a nominal range of 200 feet for RF transmitters (some transmitters have a shorter range).
• Supports RF jam detection when the receiver is enabled.
• Capable of sending status signals (Armed, Ready, etc.) to bi-directional units such as 5804BD, 5804BDV and 5828/5828V.
The following 5800 series transmitters are not intended for use in UL installations: 5802, 5834-4, 5804BD, 5804BDV,
U L
5804E, 5814, 5819, 5819BRS, 5819WHS, and 5828/5828V.
INSTALLING THE 6160RF
Locate the 6160RF in an area and at a height where it is
convenient for user operation. The 6160RF must be at least
10 ft from the control panel to ensure proper operation of the
RF receiver.
Mounting and Wiring
The 6160RF has terminal blocks for connection to power and
data wires. Removing the keypad's case back provides
access to the terminal blocks.
The 6160RF can be surface mounted directly to walls, or to a
single- or double-gang electrical box. Follow these steps to
mount and wire the keypad:
1. Push the two case release snaps at the bottom of the
keypad with the blade of a medium screwdriver (this will
push in the release snap), then pull that side of the case
back away. Insert the screwdriver in the side of the
keypad (between the front and back case) and gently
twist to release the side locking tab. Repeat for the other
side. Refer to Figure 1 for location of the case back
release snaps and locking tabs.
ARMED
READY
NOTE:
TO REMOVE REAR COVER
PUSH IN THE TWO MOUNTING
SNAPS LOCATED ALONG THE
BOTTOM OF THE KEYPAD
AND LIFT COVER UP.
MOUNTING
RELEASE
SNAPS
Figure 1. Removing the Case Back
Installation and Setup Guide
LOCKING
TAB
ADEMCO 6160RF
Keypad/Transceiver
2. Pass the wiring from the control panel through the
opening in the case back. (see the control panel's
instructions for proper run lengths.)
a. If surface wiring is being used, wiring may be routed
through the top or the bottom left-side breakout in the
case back. The breakouts must be punched out using
a screwdriver before mounting the case back.
b. If desired, wires may be strain-relieved to the wire tie
point on the inside of the case back with a tie wrap
(not supplied).
3. Mount the case back to a wall or to an electrical box using
the 25mm-long self-tapping screws supplied (mollies for
drywall are not supplied).
4. Connect the power and data wires from the control panel
to the terminals on the 6160RF as indicated in Figure 2
.
and Table 1
Figure 2 - 6160RF Wiring Details
K0903V1 2/06 Rev. F
Y +
G
WIRING TERMINALS
(TO CONTROL PANEL)