Advertisement
R
epair
[3] DISASSEMBLY / ASSEMBLY
[3]-6. Disassembling/ Assembling Motor Section (cont.)
ASSEMBLING
1) When mounting Yoke on Motor housing R, fit the notch of Yoke into
the protrusion of Motor housing R. (Fig. 14)
2) Insert Armature gear shaft to gear room of Handle R, and fix Motor housing to
Handle R by tightening 4x30 Tapping screws (4 pcs.).
Note: Magnetic force pulls Motor housing with Yoke and Armature. Therefore,
Do not pinch finger and Lead wires (Fig. 14) in this step.
3) Set Ring 30, Switch lever and Lock-off button in place, then Match Handle L
with Handle R and tighten Tapping screws. (Fig. 13)
Note: Magnetic force pulls Motor housing with Yoke and Armature. Therefore,
Do not pinch Lead wires (Fig. 15) in this step.
Fig. 15
Lock-off button
Switch lever
Fig. 14
Do not pinch finger and Lead wires between
Motor housing and Handle.
Do not pinch finger and Lead
wires in this area.
Ring 30
P 6 / 8
Notch of Yoke
Protrusion of
Motor housing R
Advertisement
