Honeywell HWS200 User Manual page 9

NOTE: THE SLIDING VALVE MUST BE CLOSED TO OPERATE THE FILTER CLEANING
SYSTEM.
NOTE that this vacuum cleaner has a built in thermal overload protector to protect the motor
from high temperatures. This can occur under heavy use. If the motor temperature shuts off
during operation, turn the switch off and allow the motor to cool for 5 minutes. Turn switch on
and resume operation.
7. When the tank needs to be emptied, see Figures 7,8:
a. Find an appropriate waste bin outside for disposal of material in the tank.
b. Turn switch off (0) and unplug power cord.
c. Detach hose from suction inlet.
d. Remove vacuum head from the tank by pulling gently on the lower part of the
clamps on the side of the vacuum head.
e. Place the vacuum head on a flat surface, resting on 2 rear legs and one front leg.
See Figure 7.
f. Empty the tank into the bin. Note the tank is equipped with a hand grip, Figure 1
(13), at the bottom for convenience.
g. Clean the post filter. See Figure 11 for instructions.
h. Attach vacuum head to tank, ensuring they are securely clamped together.
i. Insert hose into suction inlet.
! WARNING: Wear protection mask when the tank needs to be emptied.
Figure 7
Legs
Figure 8
Hand grip in
bottom, rear.
9