Honeywell HWS200 User Manual page 7

2. Be sure the switch, Figure 1 (5), is in the off position. 0 = off
3. Be sure the power cord is not plugged into an electrical outlet.
4. See Figure 2. Remove vacuum head (A) from tank (B) by pulling gently on the lower part of
the clamps (C) on the vacuum head.
5. Remove any accessories that may have been packed inside the tank.
6. Attach the vacuum head to the tank. Be sure that vacuum head is securely clamped to the
tank.
7. See Figure 3. Insert hose adaptor (A) into the intake port and turn handle (D) clockwise until
locked. To remove the hose, turn handle (D) counter clockwise until unlocked and pull the
hose adaptor (A) out.
8. See Figure 4. Adjust the suction power by moving the sliding valve (A) back and forth with
your finger tip. The suction power is highest when the sliding valve is closed and lowest
when all open.
9. Attach crevice tool, upholstery tool or brush tool to the hand tube.
I = on
Figure 2
Figure 3
Figure 4
7