Buffalo WLI2-CF-S11 User Manual page 2

■ Precautions for radio signals
● The wireless LAN card WLI2-CF-S11has been approved for conformity
to the engineering standards as the wireless facility for a radio station
with the low power data communication system based on the Wireless
Telegraphy Act. Therefore, use of this LAN card does not require any
radio station license.
● Never use the WLI2-CF-S11 near the magnetic field around a
microwave oven or in an area where static electricity and/or radio noise is
generated. The radio signals may not be normally transmitted in these
areas.
* When the WLI2-CF-S11 is used near a wireless printer buffer
(BUFFALO's RYP-G or similar products by other manufacturers) that
use radio signals around 2.4 GHz, the processing speed of both
devices may be adversely affected.
● As the WLI2-CF-S11 has been approved for conformity to the
engineering standards, the following may be regarded as unlawful.
• Disassembling/remodeling the WLI2-CF-S11
• Removing the approval label from the rear of the WLI2-CF-S11
● When it is necessary to set a radio channel other than the initial setting in
the WLI2-CF-S11, use the same frequency band as the following
equipment or wireless stations
• Industrial, scientific, or medical equipment
• Radio station for mobile identification used such as on a manufacture
line in a factory
① On-premise radio station (requiring a license)
② Specific low power radio station (requiring no license)
● Operating the WLI2-CF-S11 may cause interference with the above
equipment or radio stations. Thus, take precautions for the following
points
1 Before using the WLI2-CF-S11, verify that no on-premise radio
station for mobile identification or no specific low power radio
station is operating near the WLI2-CF-S11.
2 If an event of interference should be taken place by the WLI2-CF
-S11 with an on-premise radio station for mobile identification,