Plug-In Management - Cisco FM3200 Base Installation And Configuration Manual

Hide thumbs Also See for FM3200 Base:

Table of Contents

Figure 58. Configurator

UPGRADE dialog)

Upload the firmware image file to the unit by clicking the Choose

File button and following the software prompts.

• The Upgrade button will become available.

Click the Upgrade button. Follow the software prompts until the

firmware overwrite is complete.

• When the overwrite is complete, the unit will automatically

reboot.

If the previous firmware was overwritten with a newer version of firmware,

check that the firmware upgraded correctly by doing the following steps:

•

When the overwrite is complete, make sure that the upgraded

firmware has a greater version number than the firmware that

was previously installed.

• If the firmware version has not changed, the firmware

upgrade has failed. Repeat the overwrite from step

above.

6.7.4. Plug-In management

IMPORTANT

For a complete list of software plug-ins that are currently

available for the Cisco FM3200 Base, refer to

ins" (page

The MANAGE PLUG-INS page shows which software plug-ins are

currently active on the unit, and contains controls that allow you to do the

following functions:

• Upload activation codes that allow the unit's accessory software

plug-ins to function.

• Activate uploaded software plug-ins for use with the unit.

• Deactivate uploaded software plug-ins so they can be used on

other Cisco units.

Device configuration using the configurator interface

GUI

142).

(typical

FIRMWARE

Step 1

"Available plug-

Page 131 of 176

Table of Contents