Sony Betacam SX DNV-5 Maintenance Manual page 107

Installation
3. TC head assembly installation
(1) Put the positioning pin of the TC head
assembly into the reference hole of the
chassis and install it with two screws.
(2) Connect the harness of the TC head assembly
to connector CN2 on the HN-224 board.
(3) Hang the harness of the TC head assembly on
the hook at the top of the head as shown in
the figure.
4. TC head cleaning
Clean the TC head with cleaning cloth moistened
with cleaning fluid.
n
After cleaning, wipe the TC head with dry cloth.
Adjustment after replacement
5. Tape running confirmation
(Refer to section 4-2-1.)
6. Video tracking adjustment
(Refer to section 4-2-2.)
7. TC head height adjustment
(Refer to section 4-2-5.)
8. CTL head position confirmation
(Refer to section 4-2-4.)
9. TC head position adjustment
(Refer to section 4-2-6.)
DNV-5
DNW-7/90/90WS
Screws (P1.4 x 3.5)
Hang the harness
on the hook
HN-224 board
Reference
hole
3-3-7. TC Head Replacement
TC head assembly
Positioning pin
CN2
3-57