Sony Betacam SX DNV-5 Maintenance Manual page 104

3-3-6. CTL Head Replacement
Installation
3. CTL/FE head assembly installation
(1) Put the positioning pin of the CTL/FE head
assembly into the reference hole of the
chassis and install it with three screws.
[Tightening torque:
9 x 10
(2) Connect the harness of the CTL/FE head
assembly to connector CN505 on the MDC-5
board.
4. CTL/FE head assembly cleaning
Clean the CTL head, FE head, tape cleaner, and
tape guide with cleaning cloth moistened with
cleaning fluid.
n
After cleaning, wipe them with dry cloth.
Adjustment after replacement
5. Tape running confirmation
(Refer to section 4-2-1.)
6. Video tracking adjustment
(Refer to section 4-2-2.)
7. CTL head height adjustment
(Refer to section 4-2-3.)
8. CTL head position adjustment
(Refer to section 4-2-4.)
9. TC head position adjustment
(Refer to section 4-2-6.)
3-54
_2
N.m (0.9 kgf.cm)]
Positioning pin
MDC-5 board
Reference hole
Screws (M1.4 x 3.5)
CTL/FE head assembly
CN505
DNV-5
DNW-7/90/90WS