Faqs - NETGEAR EX6250 User Manual

AC1750 WiFi Mesh Extender

FAQs

This section provides answers for difficulties you might experience with the extender.
The web browser setup keeps asking me for my network password (passphrase)
or security key, and I am sure that I entered the correct password. What can I do?
The extender is probably placed at the borderline of the range covered by the router
or access point. To improve your signal strength, move your extender closer to your
router and make sure that the Router Link LED lights solid white or amber.
The LED lights as follows:
• Solid green. Best connection
• Solid amber. Good connection
• Solid red. Poor connection
• Off. No connection
If you are using WEP security, make sure that you are typing the network password in
the correct field.
My router security is WEP, and I entered the wrong password or security key on
the extender. I cannot access the extender anymore. What can I do?
The extender cannot check to see if the WEP password is correct. If you entered the
wrong password, your WiFi-enabled computer or mobile device is not able to get the
IP address from the extender. You must reset the extender to its factory default settings
to get the IP address back.
Can I set up the extender in extender mode if I connect it to the router or access
point with an Ethernet cable?
No. The extender is designed to connect wirelessly to the router or access point if it is
in extender mode. If the extender is in access point mode, you can connect it to the
router or access point with an Ethernet connection. For more information about access
point mode, see Install your extender in access point mode on page 14.
I am connected to NETGEAR_EXT and launched a browser and I can't I see the web
browser setup guide. What can I do?
FAQs and troubleshooting 57 User Manual