Parts & Features - Black & Decker BUFK12W Instruction Manual

SET UP & USE
PROTECTION FROM HEAT AND MOISTURE
•
Do not install your freezer in any location where heavy moisture is present or if
the location is not properly insulated. This freezer is not designed to operate
in temperature setting below 55° Fahrenheit.
•
Location for the freezer should be on a hard surface and away from direct
sunlight and heat source, e.g., radiators, baseboard heaters, cooking
appliances, etc.
DOOR ALIGNMENT
1. Remove the top hinge cover.
2. Loosen the top hinge screws using a Phillips head
screwdriver.
3. Adjust the door or put a spacer in between and then
tighten the screws.
STARTING YOUR NEW FREEZER
1. After cleaning your freezer thoroughly. Wipe the outside with a soft dry cloth, the
interior with a clean moist cloth.
2. Insert the power supply cord into the socket.
3. Turn the thermostat dial to an initial setting of "6" for 15-20 minutes.
NOTE: · As the door gets pressed in during shipping, the gasket may have to be reset. This is
done to prevent the cool refrigerated air from escaping. If there is a gap between the
door gasket and the cabinet, set the gasket by gently pulling it out of the seal gap.
PARTS & FEATURES
Temperature Control
(not shown bottom rear)
Fixed Grid
Shelf
Leveling Legs
Door Hinge Cap
Freezer
Door
Page 7