Overload Protection; Overdischarge Protection - Makita XFD15 Instruction Manual

Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
1. Indicator lamps 2. Check button
light up for a few seconds.
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
NOTE:
Tool / battery protection system
under one of the following conditions:

Overload protection

1
application that caused the tool to become overloaded.
2
Then turn the tool on to restart.
Overheat protection
This protection works and the lamp blinks when the tool
-

Overdischarge protection

Remaining
capacity
Switch action
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
malfunctioned.
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
trigger. Release the switch trigger to stop.
NOTE:
ing the switch trigger for about 6 minutes.
Electric brake
This tool is equipped with an electric brake. If the tool
is released, have the tool serviced at a Makita service
center.
6 ENGLISH
1
1. Switch trigger
CAUTION:
Before installing the battery car-
-
-