Related Manuals for Makita XPH07MB
Summary of Contents for Makita XPH07MB
- Page 1 INSTRUCTION MANUAL Cordless Hammer Driver Drill XPH07 014695 IMPORTANT: Read Before Using.
-
Page 2: Specifications
ENGLISH (Original instructions) SPECIFICATIONS Model XPH07 Drilling into concrete 16 mm (5/8") Drilling into steel 13 mm (1/2") Capacities Drilling into wood 76 mm (3") Fastening wood screw 10 mm x 90 mm (3/8" x 3-1/2") Fastening machine screw 6 mm (1/4") High (2) 0 - 2,100 /min No load speed (RPM) - Page 3 12. Prevent unintentional starting. Ensure the and the work to be performed. Use of the switch is in the off-position before connecting power tool for operations different from those to power source and/or battery pack, picking intended could result in a hazardous situation. up or carrying the tool.
- Page 4 Always be sure you have a firm footing. If electrolyte gets into your eyes, rinse them Be sure no one is below when using the tool out with clear water and seek medical in high locations. attention right away. It may result in loss of Hold the tool firmly.
-
Page 5: Functional Description
Lithium-ion batteries with a star marking are equipped FUNCTIONAL DESCRIPTION with a protection system. This system automatically cuts off power to the tool to extend battery life. The tool will automatically stop during operation if the CAUTION: tool and/or battery are placed under one of the following Always be sure that the tool is switched off and the •... -
Page 6: Switch Action
Reversing switch action not work even with a recharged battery cartridge, cool down the tool fully. If the condition does not CAUTION: change, have the tool repaired by a Makita local Always check the direction of rotation before • service center. - Page 7 Selecting the action mode ASSEMBLY CAUTION: CAUTION: Always set the ring correctly to your desired mode • mark. If you operate the tool with the ring Always be sure that the tool is switched off and the • positioned halfway between the mode marks, the battery cartridge is removed before carrying out tool may be damaged.
-
Page 8: Operation
First, slide the action mode change lever so that it Adjustable depth rod points to the marking. The adjusting ring can be aligned in any torque levels for this operation. 1. Depth rod Be sure to use a tungsten-carbide tipped bit. 2. -
Page 9: Drilling Operation
Hold the tool If you need any assistance for more details regarding firmly and exert care when the bit begins to break these accessories, ask your local Makita Service Center. through the workpiece. Drill bits A stuck bit can be removed simply by setting the •... - Page 10 < USA only > WARNING Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: •...