SPECIFICATIONS Model: XFD13 Drilling capacities Steel 13 mm (1/2") Wood 38 mm (1-1/2") Fastening capacities Wood screw 6 mm x 75 mm (1/4" x 2-15/16") Machine screw M6 (1/4") No load speed (RPM) High (2) 0 - 1,900 /min Low (1)
Page 3
Use personal protective equipment. Always Keep cutting tools sharp and clean. Properly wear eye protection. Protective equipment such maintained cutting tools with sharp cutting edges as dust mask, non-skid safety shoes, hard hat, or are less likely to bind and are easier to control. hearing protection used for appropriate conditions Use the power tool, accessories and tool bits will reduce personal injuries.
Use of non-genuine Makita batteries, or batteries that have been altered, may result in the battery bursting direct current causing fires, personal injury and damage. It will also void the Makita warranty for the Makita tool and charger. no load speed Tips for maintaining maximum battery life...
Indicating the remaining battery capacity FUNCTIONAL DESCRIPTION Only for battery cartridges with the indicator CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Installing or removing battery cartridge CAUTION: Always switch off the tool before...
When the reversing switch lever is in the neutral posi- released, have the tool serviced at a Makita service center. tion, the switch trigger cannot be pulled. Lighting up the front lamp Speed change ►...
To change the speed, switch off the tool first. Push Displayed Speed Torque Applicable the speed change lever to display "2" for high speed Number operation or "1" for low speed but high torque. Be sure that the High Heavy load- speed change lever is set to the correct position before ing operation operation.
Installing hook OPERATION CAUTION: When installing the hook, always CAUTION: Always insert the battery cartridge all the secure it with the screw firmly. If not, the hook way until it locks in place. If you can see the red indicator on the may come off from the tool and result in the personal upper side of the button, it is not locked completely.
Drilling in wood CAUTION: These accessories or attachments are recommended for use with your Makita tool When drilling in wood, the best results are obtained specified in this manual. The use of any other with wood drills equipped with a guide screw. The guide...