Table of Contents
Advertisement
5.1 Point of use (Pre-cleaning)
Pre-cleaning should be done immediately after each use.
The procedure is as follows:
1) Remove the probe cover.
2) Clean the probe of all patient's blood or fluid with running tap water
until the surface of the probe looks visually clean.
3) Wipe the whole surface of the probe with gauze pad and remove
superficial visible impurities.
5.2 Containment and transportation
Putting the contaminated equipment into exclusive
shock and damage proof container for transportation
is recommended. It is recommended that instruments are reprocessed as
soon as possible and not later than 4 hours after usage.
5.3 Manual Cleaning and disinfection
Prepare following items before manual cleaning
and disinfection:
a) Detergent: Cidezyme® (Johnson & Johnson,
#2258) or another cleaning agent with
approved material compatibility for this
medical device.
b) Disinfectant:
Johnson, # 20391) or another disinfectant
with approved material compatibility for
this medical device.
c) Two tanks, one for cleaning and one for
disinfection - optional:
1 additional tank for rinsing with deionized/tap water (sufficient
size for immersion of the submergible part of the probe at full length)
d) Soft, fluff free cloth or single use towel
e) Personal protective equipment (gloves, water repellent protective
skirt,
face
instructions
disinfectant)
Cidex®
OPA
protection
mask
of
the
manufacturer
(Johnson
&
or
protective
for
the
-17-
Point of use
(Pre-cleaning)
Containment and
transportation
Manual cleaning and
disinfection
Manual Cleaning
Rinsing after manual
cleaning
Manual Disinfection
Rinsing after manual
disinfection
glasses,
detergent
see
also
and
the
Q1E-EP1041
Advertisement
Table of Contents
