Rear Control Arm Installation - Polaris General 2020 Service Manual

r
4. Remove the fasteners connecting the lower control
arm to the chassis.
5. Examine control arm bushings and pivot tube.
Replace if worn. Discard hardware.
6. If not replacing the control arm, thoroughly clean the
control arm and pivot tube.
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
© Copyright Polaris Inc.
STEERING / SUSPENSION

REAR CONTROL ARM INSTALLATION

UPPER CONTROL ARM
q
1. Insert NEW pivot caps , control arm bushings
e
and pivot tube into new control arm..
2. Install upper control arm assembly onto vehicle
frame. Install NEW fastener
vehicle. Torque fasteners to specification.
TORQUE
Rear Inner Control Arm Fastener:
81 lb-ft (110 Nm)
w
,
r
holding control arm to
9
9.47