Table of Contents
Advertisement
Configuration mode.
The configuration mode is used to set the RAK148P2 and RAK164P2
to match the heating/cooling system. These thermostats function
with up to 2-stage heat pump systems (RAK148P2 only).
To configure the RAK148P2 and RAK164P2, perform the
following steps:
Note: Operation being set will blink in the display.
1. Slide the Function switch to the OFF position.
2. Simultaneously hold the
for 6 seconds while the thermostat is in OFF mode.
3. Press the
each screen.
4. Press the Hold button to advance to the next screen.
Note: The Mode button will return you to the previous screen.
5. To save the changes and exit configuration mode, slide the
Function switch to Heat or Cool.
Configuration Mode Settings
The setup screens for Configuration Mode are as follows:
1.
Fahrenheit or Celsius.
Press the
to select.
Press the Hold button to advance to the next screen.
NOTE: Default factory setting is Fahrenheit.
2.
(1–9°F) (1–5°C)
Set the number of degrees between the
"setpoint" temperature and the
"turn on" temperature for first stage.
Press the
Press the Hold button to advance to the next screen.
Note: Default factory setting is 2°F/1°C for each stage.
8
or
button to change settings within
or
button
or
button to set differential value.
and
buttons in
Choose
:
Advertisement
Table of Contents
