Configuration Mode - GE RAK148F2 Owner's Manual And Installation Instructions

Non-programmable

Hide thumbs

Table of Contents

The configuration mode is used to set the RAK148F2 and

RAK164F2 to match the heating/cooling system. These

thermostats function with up to 2-stage heat pump systems

(RAK148F2 only).

To configure the RAK148F2 and RAK164F2, perform the

following steps:

Note: Operation being set will blink in the display.

1. Slide the Function switch to the OFF position.

2. Remove the thermostat's front cover.

3. To enter the configuration mode, simultaneously hold

the LEFT and RIGHT buttons in for 6 seconds while the

thermostat is in OFF mode. (See diagram on page 3.)

4. Once in the configuration mode, press the

button to change settings within each screen.

- Press the RIGHT button to advance to the next screen.

- Press the LEFT button to return to the previous screen.

NOTE: To exit configuration mode at any time, slide the

Function switch to Heat or Cool.

Configuration Mode Settings

The setup screens for Configuration Mode are as follows:

1. Temperature Scale (F or C)—Choose Fahrenheit or

Celsius.

Press the

to select.

Press the RIGHT button to advance to

the next screen.

NOTE: Default factory setting is Fahrenheit.

2. Temperature Differential—Stage 1—

(1–9°F) (1–5°C)

Set the number of degrees between the

"setpoint" temperature and the

"turn on" temperature for first stage.

Press the

Press the RIGHT button to advance to the next screen.

Note: Default factory setting is 2°F/1°C for each stage.