Table of Contents
Advertisement
NOTICE:
If the base doesn't slide up or down
smoothly, the depth guide may have been tilted. In
this case, adjust the depth guide (refer the section
about adjusting the depth guide).
Bevel cutting
CAUTION:
After adjusting the bevel angle,
always tighten the lever and clamping screw
securely.
Loosen the lever and the clamping screw. Set for the
desired angle by tilting accordingly, then tighten the
lever and the clamping screw securely.
► 1 . Lever 2. Clamping screw
Positive stopper
The positive stopper is useful for setting the des-
ignated angle quickly. Turn the positive stopper so
that the arrow on it points your desired bevel angle
(22.5°/45°/60°). Loosen the lever and the clamping
screw and then tilt the tool base until it stops. The posi-
tion where the tool base stops is the angle you set with
the positive stopper. Tighten the lever and clamping
screw with the tool base at this position.
1
► 1 . Positive stopper
2
1
-1°-bevel cutting
To perform -1°-bevel cutting, loosen the lever and the
clamping screw. Set the bevel angle to -1° while turning
the stopper lever in the direction of the arrow. After that,
tighten the lever and the clamping screw.
► 1 . Stopper lever
Sighting
For straight cuts, align the 0° position on the front of the
base with your cutting line. For 45° bevel cuts, align the
45° position with it.
► 1. Cutting line (0° position) 2. Cutting line (45° position)
11 ENGLISH
1
1
2
Advertisement
Table of Contents
