Makita TD0101 Instruction Manual page 3

ENGLISH (Original instructions)
1-1. Switch trigger
2-1. Lamp
3-1. Reversing switch lever
5-1. Bit
5-2. Sleeve
6-1. Bit
SPECIFICATIONS
Capacities
No load speed (min
Impacts per minute (min
Max. fastening torque
Dimensions (L x W x H)
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for screw driving in wood, metal
and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Model TD0101F
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Explanation of general view
6-2. Bit-piece
6-3. Sleeve
8-1. Limit mark
9-1. Screwdriver
9-2. Brush holder cap
10-1. Screw
Model
Machine screw
Standard bolt
High tensile bolt
-1
)
-1
)
Net weight
Safety class
noise level determined
) : 90 dB (A)
pA
) : 101 dB (A)
WA
ENE033-1
Noise
The typical
according to EN60745:
ENF002-2
Model TD0101F
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
ENG905-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
3
10-2. Hook
10-3. Groove
11-1. Bumper
11-2. Hammer case cover
TD0101/TD0101F
4 mm - 8 mm
5 mm - 14 mm
5 mm - 10 mm
0 - 3,600
0 - 3,200
100 N·m
184 mm x 67 mm x 192 mm
0.99 kg
II
A-weighted noise
2
) : 7.5 m/s
h
2
ENG905-1
level determined
ENG901-1